Mechanical Core Chucks

| April 25, 2016

Equipment upon which Tilt-Lock Chucks are used.

  • Slitter
  • Sheeter
  • Box Maker
  • Collator
  • Tuber
  • Embosser
  • Core Cutter
  • Laminator
  • Rewinder
  • Paper Maker
  • Plastic Extruder
  • Corrugator
  • Newspaper Presses
  • Magazine Presses
  • Letter Presses
  • Offset Presses
  • Waxer
  • Breaker

Tilt Lock Mechanical Core ChuckTilt-Lock Shoulderless Style Chucks

Shoulderless Chucks are spaced at intervals along the working surface of the shaft. They are commonly used to replace expanding shafts, or when heavier torque loads assure deep tooth penetration into the core, eliminating chance of roll side drift. A Flange Chuck is used on the “closed” side of the shaft, while the Shoulderless Chuck is located approximately 3” in from the end of the roll on the opposite end of the shaft. No tools are used. You will save four to six minutes every roll change.

Tilt LockTilt-Lock, Inc.
12070 43rd Street NE | St. Michael, MN 55376
Phone: 800-999-8458 | Fax:763-497-7046
sales@tiltlock.com
www.tiltlock.com

Print Friendly

Tags:

Category: Featured Products